Page 1 of 1
Zooming between scales
Posted: Sat Aug 20, 2022 10:33 am
by woldsweather
I use Alpinequest to view my memory maps.
Is it possible to zoom from the 1 250000 scale to the 1 50000 scale and on to the 1 25000 scale and how?
Re: Zooming between scales
Posted: Sat Aug 20, 2022 5:21 pm
by geofactotem
My answer would be that you need to have both sheets available in Displayed maps and then use the opacity factor to display one or the other then zoom in the usual way.
Re: Zooming between scales
Posted: Sat Aug 20, 2022 5:44 pm
by woldsweather
OK so no way if doing it automatically like the MMap PC version.
Re: Zooming between scales
Posted: Mon Aug 22, 2022 8:01 am
by Psyberia-Support
yes just put them in the same folder
Re: Zooming between scales
Posted: Mon Aug 22, 2022 8:06 am
by woldsweather
They are all in the same folder but within that folder the 1:25000 are in one folder the 1|:50000 in another are you saying I would have to do away with the nested folders.
Re: Zooming between scales
Posted: Tue Aug 23, 2022 8:02 am
by Psyberia-Support
yes they must be in the exact same folder.
Re: Zooming between scales
Posted: Tue Aug 23, 2022 9:14 am
by woldsweather
OK. Removed all folders and dropped in 1:25000 1:50000 1: 150000 and 1:250000 for my home area but zooming in and out it stays on one scale is there some setting to adjust?
Re: Zooming between scales
Posted: Thu Aug 25, 2022 9:44 am
by Psyberia-Support
No there's no setting.
Just be sure to use the "+" and "-" zoom buttons if you want to load another map (and not pinch with 2 fingers). You can also use the double-tap zoom.
Re: Zooming between scales
Posted: Fri Aug 26, 2022 6:59 pm
by geofactotem
Hi woldsweather,
It never occurred to me that this feature was available and it closely matches the desktop Memory Map Application. Whilst of limited use to me as the maps are so old I have tested it and it does work for me. Like so much of AQ it exceeds my expectations.
I am guessing that the reason that it is not working for you is that you have not "Added as layers". When copying the map file to Available Maps - tap the 3 dots on the right and select Add as layer.
The way I have Available Maps set is:
EX160
EX145
EX133
EX132
Cycle Hike
Region02 1:50K
Base map
All except Base map (50%) and Cycle Hike (0%) are set at 100% opacity.
I use the slider to zoom as I find it easier to use when I am walking. If when looking at region02 and I move the map centre over an area with a supporting 1:25K sheet and zoom in it will change the scale and display the 1:25K sheet. It is a bit slower in reverse as it has more to draw.
If you have elected to display the map name it does not change with the map change (I think this has been reported in a different usage) but it is so trivial as to be not worth worrying about.
Regards
David