The support forum is temporarily read-only. For urgent requests, please email contact[at]psyberia.net

[done] Request target distance in miles rather than feet

Any question about the app? Ask it here
Post Reply
WyeWalk
Posts: 17
Joined: Mon Sep 01, 2014 12:50 pm

[done] Request target distance in miles rather than feet

Post by WyeWalk »

Congratulations on a fantastic app, which I have been using for a few years now.
On every GPSr I have ever used (except Magellan) when using imperial units and navigating to a location the target distance is shown in miles until the target is closer than 0.1 miles away, then it switches to feet. AQ gives this distance in feet once the target is closer than 1 mile away. I find this difficult to use.
For example, 3690' is not very helpful to me and I have to go through the process of mentally trying to work out what fraction of a mile that equates to, whereas 0.75 miles is much simpler. :)
Would it be possible for you to make this change?
Psyberia-Support
Site Admin
Posts: 6408
Joined: Wed Apr 14, 2010 9:41 pm

Re: Request target distance in miles rather than feet

Post by Psyberia-Support »

Hi,
Ok no problem, I'll change this in the next update.
Thanks for the feedback!
Best regards
Do you like AlpineQuest ? Leave a small comment on Google Play !
Psyberia-Support
Site Admin
Posts: 6408
Joined: Wed Apr 14, 2010 9:41 pm

Re: Request target distance in miles rather than feet

Post by Psyberia-Support »

Update: as of version 2.0.6 you may need to choose another (imperial) distance unit to get this behavior, as the original unit will re-use feet up to one mile following this topic.
Do you like AlpineQuest ? Leave a small comment on Google Play !
Post Reply